HP Model 715/80 hp 9000 series 700 model 715 workstations service handbook (a2 - Page 69
Stable Storage
View all HP Model 715/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
S Set or display the Fastsize value (amount of memory initialized during boot) using the FASTSIZE command. S Display a menu of commands using the HELP command or a description of any command as an option to the HELP command. S Display the model number, version numbers, and jumper settings on the System card using the INFO command. S Display the current STATION ADDRESS value in stable storage using the LAN_ADDR command. You must use SS_CONFIG to set this value. S Select an operating system for the next boot attempt using the OS command. S Set or display the current values for the console, keyboard, primary, or alter- nate boot paths using the PATH command. S Display the most recent HPMC, LPMC, or TOC error information logged into Stable Storage using the PIM_INFO command. S Reset the System Unit using the RESET command. S Search for possible boot devices using the SEARCH command. S Set or display secure boot mode or the ability to interact with the console de- vice within the first 10 seconds before boot device selection is disabled using the SECURE command. S Display the results of the previous search command using the SHOW command (this command is not supported on Model 715/64, 715/80, , 715/100, and 715/100XC workstations). Syntax checking is performed for any supported commands. Error status is displayed on the console along with any relevant information. Stable Storage Stable Storage is non-volatile memory associated with each PA-RISC processor module. Stable storage is used by the processor (CPU) to store device path information, the state of the boot flags, HPMC error information, and operating system initialization data. Troubleshooting 4-15