HP Nc4000 HP Compaq nc4010 Notebook PC - Maintenance and Service Guide - Page 108
Remove the fan, making sure the fan cable clears the screw
View all HP Nc4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Removal and Replacement Procedures 4. Disconnect the fan cable 1 from the system board. 5. Remove the three PM2.0×3.0 screws 2 that secure the fan to the heat sink. 6. Remove the fan, making sure the fan cable clears the screw next to the cable clip 3. Removing the Fan Reverse the above procedure to install the fan. Ä CAUTION: When installing the fan in the heat sink, make sure the fan cable is not crimped by the screw next to the cable clip. If the cable is crimped and damaged, the fan will not cool the notebook internal components, which could result in damage. Maintenance and Service Guide 5-29
Removal and Replacement Procedures
Maintenance and Service Guide
5–29
4. Disconnect the fan cable
1
from the system board.
5. Remove the three PM2.0×3.0 screws
2
that secure the fan
to the heat sink.
6. Remove the fan, making sure the fan cable clears the screw
next to the cable clip
3
.
Removing the Fan
Reverse the above procedure to install the fan.
Ä
CAUTION:
When installing the fan in the heat sink, make sure the fan
cable is not crimped by the screw next to the cable clip. If the cable is
crimped and damaged, the fan will not cool the notebook internal
components, which could result in damage.