HP Nc4000 HP Compaq nc4010 Notebook PC - Maintenance and Service Guide - Page 137
Two T8M2.0×6.0 screws, in front of the hard drive bay
![]() |
View all HP Nc4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Removal and Replacement Procedures 2. Position the base enclosure so the rear panel is facing toward you. 3. Remove the following screws: ❏ Two T8M2.0×6.0 screws 1 from the rear panel ❏ One T8M2.0×4.0 screw 2 in the upper right corner of the system board ❏ One T8M2.0×4.0 screw 3 in front of the hard drive bay ❏ One T8M2.0×4.0 screw 4 in the lower left corner of the system board 4. Use a 5.0-mm socket to remove the two M2.0×9.0 standoffs 5 that secure the system board to the base enclosure. Removing the System Board Screws 5-58 Maintenance and Service Guide
![](/manual_guide/products/hewlettpackard-nc4000-hp-compaq-nc4010-notebook-pc-maintenance-service-guide-c978250/137.png)
5–58
Maintenance and Service Guide
Removal and Replacement Procedures
2. Position the base enclosure so the rear panel is facing
toward you.
3. Remove the following screws:
❏
Two T8M2.0×6.0 screws
1
from the rear panel
❏
One T8M2.0×4.0 screw
2
in the upper right corner of
the system board
❏
One T8M2.0×4.0 screw
3
in front of the hard drive bay
❏
One T8M2.0×4.0 screw
4
in the lower left corner of
the system board
4. Use a 5.0-mm socket to remove the two M2.0×9.0
standoffs
5
that secure the system board to the base
enclosure.
Removing the System Board Screws