HP ProDesk 600 Hardware Reference Guide - Page 26
Installing additional memory, DIMMs, DDR3-SDRAM DIMMs, Populating DIMM sockets
View all HP ProDesk 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
No. System Board Connector 19 SATA 3.0 System Board Label Color SATA2 light blue 20 USB 2.0 MEDIA black Component Any SATA Device other than the Primary Hard Drive USB 2.0 Device, such as a Media Card Reader Installing additional memory The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3SDRAM) dual inline memory modules (DIMMs). DIMMs The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 32-GB of memory configured in a high-performing dual channel mode. DDR3-SDRAM DIMMs For proper system operation, the DDR3-SDRAM DIMMs must be: ● industry-standard 240-pin ● unbuffered non-ECC PC3-12800 DDR3-1600 MHz-compliant ● 1.35 volt or 1.5 volt DDR3/DDR3L-SDRAM DIMMs The DDR3-SDRAM DIMMs must also: ● support CAS latency 11 DDR3 1600 MHz (11-11-11 timing) ● contain the mandatory JEDEC SPD information In addition, the computer supports: ● 512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies ● single-sided and double-sided DIMMs ● DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported NOTE: The system will not operate properly if you install unsupported DIMMs. Populating DIMM sockets There are four DIMM sockets on the system board, with two sockets per channel. The sockets are labeled DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM1 and DIMM2 operate in memory channel B. Sockets DIMM3 and DIMM4 operate in memory channel A. The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending on how the DIMMs are installed. 18 Chapter 2 Tower (TWR) hardware upgrades ENWW