HP ProDesk 600 Hardware Reference Guide - Page 83
Replace the front bezel.
View all HP ProDesk 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
11. If installing a USB 3.0 media card reader, you must use the USB 3.0 to USB 2.0 adapter and connect the adapter cable from the media card reader to the USB 2.0 connector on the system board labeled MEDIA. NOTE: Refer to System board connections on page 60 for an illustration of the system board drive connectors. 12. Rotate the drive cage back down to its normal position. CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down. 13. Replace the front bezel. 14. Replace the computer access panel. 15. If the computer was on a stand, replace the stand. ENWW Installing and removing drives 75
11.
If installing a USB 3.0 media card reader, you must use the USB 3.0 to USB 2.0 adapter and
connect the adapter cable from the media card reader to the USB 2.0 connector on the system
board labeled MEDIA.
NOTE:
Refer to
System board connections
on page
60
for an illustration of the system board
drive connectors.
12.
Rotate the drive cage back down to its normal position.
CAUTION:
Be careful not to pinch any cables or wires when rotating the drive cage down.
13.
Replace the front bezel.
14.
Replace the computer access panel.
15.
If the computer was on a stand, replace the stand.
ENWW
Installing and removing drives
75