HP ProDesk 600 Hardware Reference Guide - Page 43
Replace the computer access panel., Replace the front bezel.
View all HP ProDesk 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
8. Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until the drive snaps into place. 9. If installing a USB 3.0 media card reader, you must use the USB 3.0 to USB 2.0 adapter and connect the adapter cable from the media card reader to the USB 2.0 connector on the system board labeled MEDIA. NOTE: Refer to System board connections on page 60 for an illustration of the system board drive connectors. 10. Replace the front bezel. 11. Replace the computer access panel. 12. Reconnect the power cord and any external devices, then turn on the computer. 13. Lock any security devices that were disengaged when the access panel was removed. ENWW Installing and removing drives 35
8.
Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place.
9.
If installing a USB 3.0 media card reader, you must use the USB 3.0 to USB 2.0 adapter and
connect the adapter cable from the media card reader to the USB 2.0 connector on the system
board labeled MEDIA.
NOTE:
Refer to
System board connections
on page
60
for an illustration of the system board
drive connectors.
10.
Replace the front bezel.
11.
Replace the computer access panel.
12.
Reconnect the power cord and any external devices, then turn on the computer.
13.
Lock any security devices that were disengaged when the access panel was removed.
ENWW
Installing and removing drives
35