HP SignagePlayer mp8000s Maintenance & Service Guide: HP SignagePlayer mp8 - Page 88
Front Fan Assembly
View all HP SignagePlayer mp8000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Front Fan Assembly The front fan assembly is attached to the front of the chassis. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 35). 2. Remove the access panel (Computer Access Panel on page 43). 3. Remove the front bezel (Front Bezel on page 44). 4. Remove the baffle (Baffle on page 77). 5. Disconnect the fan cable from the red/brown system board connector labeled CHFAN1. 6. Press the two tabs (one of left, one on bottom) that secure the fan assembly to the front of the chassis. Figure 6-55 Removing the front fan 7. Pull the assembly toward the rear of the unit, and then lift it out of the chassis. To install the front fan, reverse the removal procedure. Be sure to orient the air flow into the unit. 78 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis