HP StorageWorks 1000i HP StorageWorks 1000i Virtual Library System User Guide - Page 44
Microsoft's iSCSI
View all HP StorageWorks 1000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
If you are using software drivers, use following procedure to install Microsoft's iSCSI Software Initiator. NOTE: You do not need TOE-equipped (Transmission Control Protocol [TCP] Offload Engine) or special iSCSI-capable GbE HBAs to work with software initiators. Any standard Network Interface Card (NIC) can serve as an iSCSI network interface device; however, HP Storage strongly recommends that you use GbE for enhanced performance. 1. Download the appropriate iSCSI initiator file for your platform from this URL: http://www.microsoft.com/downloads/details.aspx?FamilyID=12cb3c1a-15d6-4585-b385 befd1319f825&DisplayLang=en The file name will likely end in x86fre.exe. 2. Double-click the initiator file to start installing the Microsoft iSCSI Initiator. 3. In the Software Update Installation Wizard, click Next. 4. Under Installation Options, select both Initiator Service and Software Initiator. Click Next. 5. In the License Agreement window please read the agreement, then select I Agree. Click Next. The installation proceeds. 6. When the installation finishes, click Finish. 7. If necessary, reboot the system. 8. After the system reboots, select Start > All Programs > Microsoft iSCSI Initiator > Microsoft iSCSI Initiator. 9. In the iSCSI Initiator Properties window, select the Discovery tab. At this time, no items are listed under Target Portals. 10. In the Target Portals section, click Add. 11. In the Add Target Portal window, enter the IP address of your VLS. Maintain the default port setting. Click OK. 44 Configuring the VLS1000i