HP StorageWorks 1500cs HP StorageWorks 1500 Modular Smart Array maintenance an - Page 53
Controller Disabled, Autoflash Started
View all HP StorageWorks 1500cs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Message 151 BEACON OFF Type Informational 201 ARRAY CONTROLLER TEMPERATURE OK Informational 202 ARRAY CONTROLLER OVERHEATING Error 203 ARRAY CONTROLLER OVERHEATED Error 204 ARRAY Error CONTROLLER DISABLED 205 ARRAY CONTROLLER RESTARTING 300 RECOVERY ROM AUTOFLASH STARTED Informational Informational Description Action The LEDs on the MSA and all connected hard drives are no longer blinking because the host-based application is no longer identifying or configuring this MSA. The temperature sensor on the array controller indicates that the temperature that was previously exceeding the normal operating range is now back within the range. The temperature sensor on the array controller indicates that the array controller is starting to exceed the normal operating range. Check all MSA fans and ensure they are operating. Any failed fan should be replaced. Ensure that there is a module or blanking panel (cover plate) in all MSA chassis bays and slots. Empty bays affect the airflow and cooling ability of the MSA. The temperature sensor on the array controller indicates that the array controller has exceeded the safe operating range. The MSA should be powered off as soon as possible to avoid hardware failure. Check all MSA fans and ensure they are operating. Any failed fan should be replaced. Ensure that there is a module or blanking panel (cover plate) in all MSA chassis bays and slots. Empty bays affect the airflow and cooling ability of the MSA. The array controller has been disabled due to a redundancy failure. Remove the failed array controller, wait 10 seconds, and then reinsert the array controller, ensuring that it is fully seated in the chassis. Should the issue persist, contact HP support. The array controller has completed firmware cloning and will be restarted automatically. The array controller has detected that the firmware's backup recovery ROM image is invalid and is copying the current active firmware image into the backup recovery ROM. maintenance and service guide 53