HP StorageWorks 1500cs HP StorageWorks 1500 Modular Smart Array maintenance an - Page 58
MEMORY ERROR SEEN, the Fibre Channel I/O bay.
View all HP StorageWorks 1500cs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Message 511 FIBRE CHANNEL SUBSYSTEM HARDWARE FAILURE Type Error 513 UNCORRECTED ECC Error MEMORY ERROR SEEN 514 FIBRE SWITCH HARDWARE FAILURE Error 515 FIBRE DEVICE HARDWARE FAILURE Error 516 FIBRE SUBSYSTEM Error LINK FAILURE Description Action The array controller's Fibre Channel subsystem has encountered a critical error during the power up sequence. Remove the failed array controller and its associated Fibre Channel module, reseat the Fibre Channel daughter card on the array controller, wait 10 seconds, then reinsert the Fibre Channel module and the array controller, ensuring that they are fully seated in their respective bays in the chassis. Should the issue persist, contact HP support. The array controller has detected an uncorrectable error in the ECC memory on the memory cache board. Remove the failed array controller and replace the memory cache board with a new one. The embedded switch in the Fibre Channel I/O bay is not responding correctly or is not working. (Please note that some switches take several minutes to start up.) Remove the embedded switch, wait 10 seconds, and then reinsert the switch, ensuring that it is fully seated in the chassis. Should the issue persist, contact HP support. The array controller firmware does not recognize the device in the Fibre Channel I/O bay. The device has failed or is not supported by the installed firmware version. If the device was not recently installed or the firmware was not recently downgraded, remove the embedded device, wait 10 seconds, and then reinsert the device, ensuring that it is fully seated in the chassis. Should the issue persist, contact HP support. The controller is not currently linked to anything. This could be due to the following: • The Fibre Channel cable is not connected. • The device to which it is connected is currently not working. • The MSA is connected to a device that with an incompatible port type. Check the connections on both ends of the Fibre Channel cables and make sure that the switch, hub, or other system that the fibre is connected to is operating properly and is properly configured. Should the issue persist, contact HP support. 517 FIBRE SUBSYSTEM Informational LINK OK The Fibre Channel port has transitioned to an online state. 58 LCD panel and message descriptions