HP StorageWorks 2/128 HP StorageWorks SAN Director 2/128 Fabric OS V4.2.x Rele - Page 24

Issues and Workarounds Table 6: Issues and Workarounds (Continued) Issue Web Tools shows incorrect current value on the smart sfp. Web Tools does not show duplicate entries contained in zoning on switch, so you cannot delete the duplicate entry. The CP error SIOCADDRT: No such device occurs on two separate SAN Director 2/128 CP blades. For debugging usage, PortID in the portlogdump should refer to the area number of the switchshow when Extended Edge PID is set. Incompatible flow control warning messages should refer to the area number of the switchshow when extended Edge PID (format 2) is set. Web Tool events use UTC time, rather than adjusted timezone time. Workaround Use the sfpshow command to display the correct value of current. Deleting one member out of the zone list from the Telnet session may resolve the issue. This problem can be mitigated by not setting the switch IP address from multiple Telnet or application sources (Telnet windows, Web Tools, Fabric Manager, and so on). If you do see the SIOCADDRT error message, you can resolve the problem by properly setting the IP address with the ipAddrSet command. Note that after running portlogdump, the PortID is the logical linear port number, not the area number. In switch PID format 2 (Extended Edge PID format), this error message is shown as a logical linear port, which is different from the area number of switchshow. Add 16 to the logical linear port number to match the switchshow area number. Note that Web Tools and CLI event time are not the same when the tstimezone is configured. When tstimezone is not configured, the event times match. 24 SAN Director 2/128 Fabric OS 4.2.x Release Notes