HP StorageWorks 2/140 director 2/140 rack mount kit installation instructions - Page 17
Installing Shelf Brackets in an HP Rack System/e or 19-inch EIA Rack
![]() |
View all HP StorageWorks 2/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions Installing Shelf Brackets in an HP Rack System/e or 19-inch EIA Rack The shelf brackets mount directly to the interior vertical rails of the HP rack system/e or 19-inch EIA rack using cage nuts and Phillips panhead screws. Use these steps to install the two shelf brackets in an HP rack system/e or 19-inch EIA rack. 1. Determine the appropriate placement for the Director inside the rack. NOTE: HP strongly recommends installing the Director 2/140 in the lowest position in the rack. 2. Along an exterior vertical rail of the rack cabinet, determine the position of the bottom of the shelf bracket and count 1 U up from this location. 3. Use a straight edge to locate the corresponding rack holes along the interior vertical rails of the rack cabinet. Mark this location on each interior vertical rail. 4. Install two cage nuts along one interior vertical rail as marked in step 3, leaving one empty rack hole between the cage nuts. 5. Repeat step 4 for each of the three remaining interior vertical rails. 6. Secure a shelf bracket to the interior vertical rails using four (4) Phillips panhead screws with split lock and flat washers. 7. Repeat step 6 to secure the second shelf bracket on the opposite side of the rack. 8. Continue to "Attaching the Mounting Hardware to the Director 2/140" on page 8. director 2/140 rack mount kit installation instructions 7
![](/manual_guide/products/hewlettpackard-storageworks-2140-director-2140-rack-mount-kit-installation-instructions-764d749/17.png)