HP StorageWorks 2/140 director 2/140 rack mount kit installation instructions - Page 20

Installation Instructions Installing the Director 2/140 in the Rack Use these steps to maneuver the Director 2/140 into the rack: 1. Using a lift device, position the Director 2/140 at the front of the cabinet. 2. If necessary, adjust the lift height so that the bottom of the Director 2/140 is parallel with the shelf mounts in the rack. 3. Slide the Director along the shelf mounts and into the cabinet until the front mounting brackets on the Director 2/140 contact the front cabinet rails. Securing the Front Mounting Brackets to the Rack Follow this procedure to secure the front mounting brackets attached to the Director 2/140 to the rack: 1. Secure one of the front mounting brackets to a cabinet rail by attaching three Phillips panhead screws to the cage nuts you installed earlier. 2. Repeat step 1 to secure the other front mounting bracket to the remaining cabinet rail. Securing the Rear Mounting Brackets to the Rack Follow this procedure to attach the Director 2/140 rear mounting plates to the rack using the rear mounting bracket: 1. Align a rear mounting bracket with the cage nuts you installed earlier, and the screw holes in the rear mounting plate attached to the Director 2/140. 2. Attach a rear mounting bracket to a rear mounting plate by installing three Phillips panhead screws in the mounting plate holes. Do not tighten. 3. Adjust the position of the rear bracket so that the holes align with the cage nuts installed in the cabinet rail. 4. Attach the rear mounting bracket to the cage nuts installed in the cabinet rail using three Phillips panhead screws. Tighten securely. 5. Tighten the screws attached to the rear mounting plate. 6. Repeat step 1 through step 5 to attach a rear mounting bracket to the remaining rear rail. 10 director 2/140 rack mount kit installation instructions