HP StorageWorks 2/8-EL SAN switch 2/8 version 3.0.x installation guide - Page 40
Installing the tinnerman clips
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Installing the SAN Switch 2/8 3. Install two M5 U-type Tinnerman clips for each of the front columns of the rack in the top and bottom positions of the three-hole EIA pattern as shown in Figure 9. 2 1 SHR-255 1 M5 U-type tinnerman clips 2 Upright rack post Figure 9: Installing the tinnerman clips 4. Assemble the outer rails by completing the following steps: a. As an aid in assembly, two rubber washers have been included to help keep the rear slotted portion of the outer rail flush against the rear rail-tray brackets. Install them as shown in Figure 10. 40 hp StorageWorks SAN Switch 2/8 Installation Guide
Installing the SAN Switch 2/8
40
hp StorageWorks SAN Switch 2/8 Installation Guide
3.
Install two M5 U-type Tinnerman clips for each of the front columns of the
rack in the top and bottom positions of the three-hole EIA pattern as shown in
Figure 9
.
Figure 9:
Installing the tinnerman clips
4.
Assemble the outer rails by completing the following steps:
a.
As an aid in assembly, two rubber washers have been included to help
keep the rear slotted portion of the outer rail flush against the rear rail-tray
brackets. Install them as shown in
Figure 10
.
1
M5 U-type tinnerman clips
2
Upright rack post
SHR-255
1
2