HP StorageWorks 2/8-EL SAN switch 2/8 version 3.0.x installation guide - Page 48
Connecting the Serial cable, Parity: None
![]() |
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Installing the SAN Switch 2/8 2. Connect the Serial cable to the SAN Switch 2/8 Serial port, see Figure 15. Figure 15: Connecting the Serial cable SHR-2497B 3. Connect the other end of the Serial cable to an RS-232 Serial port on the workstation. If no RS-232 Serial port is available on the workstation, the adapter on the end of the Serial cable can be removed to use the RJ-45 connector to create a Serial connection. 4. Verify that the switch power is on and POST is completed. See the "Power On Self-Test" section, on page page 46 in this chapter. 5. Power on the workstation and establish a connection to the switch using a terminal emulator application (such as Hyperterminal). Note: Step 6 shows instructions specific to HyperTerminal. If using a different application, consult the specific application's documentation. 6. Using Hyperterminal configure the port settings as follows: ■ Bits per second: 9600 ■ Databits: 8 ■ Parity: None ■ Stop bits: 1 ■ Flow control: None 48 hp StorageWorks SAN Switch 2/8 Installation Guide
![](/manual_guide/products/hewlettpackard-storageworks-28el-san-switch-28-version-30x-installation-guide-e5002d2/48.png)