HP StorageWorks 2/8-EL SAN switch 2/8 version 3.0.x installation guide - Page 88
Serial Port Specifications, Table 9: Cabling Pinouts if Pin 7 is Used
![]() |
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Technical Specifications Serial Port Specifications The Serial port can be used to connect to a computer workstation to configure the switch IP address without connecting to the fabric. The Serial port's parameters are 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control. The port requires a straight serial cable with a female 9-pin subminiature-D connector. Only pins 2, 3, and 5 are supported; if pin 7 is used, the signal must always be driven high, using the pinouts listed in Table 9. Table 9: Cabling Pinouts if Pin 7 is Used PIN 1 2 3 4 5 6 7 8 9 Signal Description TxData RxData Transmit Data Receive Data GND Logic Ground CTS Clear to Send Note: For dust and ESD (electrostatic discharge) protection, a cover is provided for the serial port and should be kept on the port whenever the serial port is not in use. 88 hp StorageWorks SAN Switch 2/8 Installation Guide
![](/manual_guide/products/hewlettpackard-storageworks-28el-san-switch-28-version-30x-installation-guide-e5002d2/88.png)