HP StorageWorks 2/8-EL SAN switch 2/8 version 3.0.x installation guide - Page 42
Assembling the outer rails, lock washers and eight #8 flat washers as shown
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installing the SAN Switch 2/8 1 2 SHR-2560A 1 Outer rail alignment pins 2 M5 torx screws Figure 11: Assembling the outer rails 5. Assemble each of the two inner rails (one on each side of the switch and plenum) using eight #8-32 x 5/16 Phillips pan-head screws (with attached star lock washers) and eight #8 flat washers as shown in Figure 12. Caution: Do not use any other screws other than the eight that are provided. Use of any longer lengths can cause damage to internal components of the switch. Be sure to install the flat washers along with the pan-head screws. Before tightening screws, make sure that the rails are centered to the overall height of the switch. 42 hp StorageWorks SAN Switch 2/8 Installation Guide
Installing the SAN Switch 2/8
42
hp StorageWorks SAN Switch 2/8 Installation Guide
Figure 11:
Assembling the outer rails
5.
Assemble each of the two inner rails (one on each side of the switch and
plenum) using eight #8-32 x 5/16 Phillips pan-head screws (with attached star
lock washers) and eight #8 flat washers as shown in
Figure 12
.
Caution:
Do not use any other screws other than the eight that are provided.
Use of any longer lengths can cause damage to internal components of the
switch. Be sure to install the flat washers along with the pan-head screws.
Before tightening screws, make sure that the rails are centered to the overall
height of the switch.
1
Outer rail alignment pins
2
M5 torx screws
1
2
SHR-2560A