HP StorageWorks 2/8-EL SAN switch 2/8 version 3.0.x installation guide - Page 75
Restoring the System Configuration Settings, Shut down the switch by entering the following command
![]() |
View all HP StorageWorks 2/8-EL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Saving Configuration Settings and Upgrading Firmware Restoring the System Configuration Settings Use these steps to restore the system configuration settings from a backup. 1. Verify that the RSHD service or the FTP service is running on the host workstation. 2. Log in to the switch as the admin user. 3. Shut down the switch by entering the following command: switchDisable 4. At the command line enter the following command: configDownload hostIPaddr, user, path_filename,password For example, hostIPaddr is the IP address of the host computer, user is the User ID used to log into this computer, path_filename is the path location and filename of the system configuration file, and password is the password for the user ID specified. Note: The password operand is only required if you are using FTP. 5. Reboot the switch by entering the following command: fastBoot hp StorageWorks SAN Switch 2/8 Installation Guide 75
![](/manual_guide/products/hewlettpackard-storageworks-28el-san-switch-28-version-30x-installation-guide-e5002d2/75.png)