HP StorageWorks 4/256 Brocade Converged Enhanced Ethernet Command Reference v6 - Page 138
seq extended MAC ACLs, Synopsis, permit, count, no seq, Operands, permit or deny, Defaults, Command
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
8 seq (extended MAC ACLs) seq (extended MAC ACLs) Inserts a rule anywhere in the MAC ACL. Synopsis seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL} [EtherType |arp |fcoe | ipv4] [count] no seq value Operands value Specifies the sequence number for the rule. The range of valid values is 0-65535. permit or deny Specifies rules to permit or deny traffic. any Specifies any source MAC address. host MAC_ACL Specifies the source host MAC address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. MAC_ACL Specifies the source host MAC address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. any Specifies any destination MAC address. host MAC_ACL Specifies the destination host address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. MAC_ACL Specifies the destination host address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. Ethertype Specifies the protocol number for which to set the permit or deny conditions. The range of valid values is 1536-65535. arp Specifies to permit or deny the Address Resolution Protocol (0x0806). fcoe Specifies to permit or deny the Fibre Channel over Ethernet Protocol (0x8906). ipv4 Specifies to permit or deny the IPv4 protocol (0x0800). count Enables the counting of the packets matching the rule. Defaults By default, no MAC ACLs are configured. Command Feature Access Control List Configuration mode Modes Description Use this command to insert a rule anywhere in the MAC ACL; it configures rules to match and permits or drops traffic based on the source and destination MAC addresses, and the protocol type. You can also enable counters for a specific rule. There are 255 ACL counters supported per port group. Use the no seq value command to remove a rule from the MAC ACL. Usage Guidelines The first set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the source MAC address. The second set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the destination MAC address. 120 Converged Enhanced Ethernet Command Reference 53-1001347-01