HP StorageWorks 4/256 Brocade Converged Enhanced Ethernet Command Reference v6 - Page 189
QoS Commands
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
QoS Commands Chapter 11 cee Applies a CEE Provisioning map on an interface. Synopsis cee name no cee Operands name Specifies the name of a previously created CEE map. Any existing CEE map must be removed before a new one can be applied. Defaults There is no CEE Provisioning applied on an interface. Command Interface configuration mode Modes Description Use this command to apply a CEE map on an interface. Use the no cee command to remove the CEE Provisioning map. Usage The CEE map applied on an interface should exist on the switch. Guidelines Examples To apply a CEE map on an interface: switch(conf-if-te-0/1)#cee demo Because the switch does not allow applying a CEE map that does not exist, the following error displays: switch(conf-if-te-0/1)#cee test % Error: Map does not exist See Also cee-map Converged Enhanced Ethernet Command Reference 171 53-1001347-01