HP StorageWorks 4/256 Brocade Fabric OS Command Reference Guide v6.0.0 (53-100 - Page 66
To set the Switch policy to active mode
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
2 authUtil See Also Authentication is set to dhchap. To set both protocols in order of FCAP and then DH-CHAP: switch:admin> authutil --set -a all Authentication is set to fcap,dhchap. To set DH group 3: switch:admin> authutil --set -g 3 DH Group was set to 3. To set all DH groups to be specified in auth negotiation in order of 0, 1, 2, 3, and 4: switch:admin> authutil --set -g "*" DH Group is set to 0,1,2,3,4 To set the Switch policy to active mode: switch:admin> authutil --policy -sw active Warning: Activating the authentication policy requires either DH-CHAP secrets or PKI certificates depending on the protocol selected. Otherwise, ISLs will be segmented during next E-port bring-up. ARE YOU SURE (yes, y, no, n): [no] y Auth Policy is set to ACTIVE To set the Device policy to passive mode: switch:admin> authutil --policy -dev passive Warning: Activating the authentication policy requires DH-CHAP secrets on both switch and device. Otherwise, the F-port will be disabled during next F-port bring-up. ARE YOU SURE (yes, y, no, n): [no] y Device authentication is set to PASSIVE To start authentication on E/F ports 2, 3, and 4: switch:admin> authutil --authinit 2,3,4 portShow, secAuthSecret 40 Fabric OS Command Reference 53-1000599-01