HP StorageWorks 4/256 Brocade Fabric OS Command Reference Guide v6.0.0 (53-100 - Page 682
trunkDebug, Synopsis, Description, Operands, switchShow, Examples, See Also, portCfgTrunkPort
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 682 highlights
2 trunkDebug trunkDebug Debugs a trunk link failure. Synopsis trunkdebug port1 port2 Description Use this command to debug a trunk link failure. This command reports one of the following messages, based on the trunking properties of the two specified ports: • Switch does not support trunking • Trunking license required • Trunking not supported in switch interop mode • port port_id is not E_Port • port port_id trunking disabled • port port_id speed is not 2G or 4G • port port_id and port port_id are not in same port group • port port_id and port port_id connect to different switches • port port_id and port port_id connect to the switch WWN • port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at remote port • port port_id and port port_id cannot trunk, please check link length to make sure difference is less than 400 m The execution of this command is subject to Admin Domain restrictions that may be in place. Operands This command has the following operands: port1 Specify the area number of port 1. Use the switchShow command to view the area numbers for a port. This operand is required. port2 Specify the area number of port 2. Use the switchShow command to view the area numbers for a port. This operand is required. Examples To debug a trunk connection: switch:admin> trunkdebug 43 44 Switch does not support trunking switch:admin> trunkdebug 62 63 port 62 and 63 are trunked together See Also portCfgTrunkPort, switchCfgTrunk, trunkShow 656 Fabric OS Command Reference 53-1000599-01