HP StorageWorks 4/64 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 111
Auth-1008, Auth-1010, Auth-1011
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
AUTH-1008 4 Recommended Action Run the authUtil command to make sure the local switch supports the specified protocols: Fibre channel authentication protocol (FCAP) or Diffie Hellman - challenge handshake authentication protocol (DH-CHAP). Severity ERROR AUTH-1008 Message , [AUTH-1008], ,, ERROR, , No security license, operation failed. Probable Cause Indicates that the switch does not have a security license. Recommended Verify that the security license is installed using the licenseShow command. If necessary, reinstall Action the license using the licenseAdd command. Severity ERROR AUTH-1010 Message , [AUTH-1010], ,, ERROR, , Failed to initialize security policy: switch , error . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reboot or power cycle the switch. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1011 Message , [AUTH-1011], ,, WARNING, , Failed to register for failover operation: switch error . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity WARNING Fabric OS Message Reference 41 53-1001338-01