HP StorageWorks 4/64 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 215
EM-1006, Message, Probable Cause, Recommended, Action, Severity, lscfg
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
22 EM-1006 EM-1006 Message , [EM-1006], , FFDC, CRITICAL, , has faulted. Sensors below minimum limits. Probable Cause Indicates that the sensors show the voltage is below minimum limits. The switch or specified blade is being shut down for environmental reasons; the voltage is too low. Recommended Action If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the blade. If this problem occurs on a switch, it usually indicates a hardware problem on the main board; replace the switch. Severity CRITICAL EM-1007 Message , [EM-1007], , FFDC, CRITICAL, , is being reset. Sensors has exceeded max limits. Probable Cause Indicates that the voltage on a switch has exceeded environmental limits. A reset is sent to the faulty slot or the switch for nonbladed switches. Recommended Action There is most likely a voltage hardware problem on the blade or motherboard of the switch. For the Brocade DCX, 24000 and 48000, replace the blade field-replaceable unit (FRU). For the Brocade 3900 replace the motherboard FRU. For the Brocade 200E, 3016, 3250, 3850, 4012, 4016, 4018, 4020, 4024, 4100, 4900, 5000, 7500, AP7600, replace the switch. Severity CRITICAL EM-1008 Message , [EM-1008], , FFDC, CRITICAL, , Unit in with ID is faulted, it is incompatible with the configuration. Probable Cause Indicates that a blade inserted in the specified slot or the switch (for nonbladed switches) is not compatible with either the platform configuration or the logical switch configuration. The blade is faulted. Recommended Action If the blade is not compatible, replace the blade and ensure the replacement blade is compatible with your control processor (CP) type. If the incompatibility is with the logical switch configuration, change the configuration with the lscfg command to be consistent with the blade type or remove the blade. Severity CRITICAL Fabric OS Message Reference 145 53-1001338-01