HP StorageWorks 4/64 Brocade Fabric OS Message Reference v6.3.0 (53-1001338-01 - Page 539
PORT System Messages
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 539 highlights
Chapter PORT System Messages 79 PORT-1003 Message , [PORT-1003], ,, WARNING, , Port Faulted because of many Link Failures Probable Cause Indicates that the specified port is now disabled because the link on this port had multiple failures that exceeded an internally set threshold on the port. This problem is typically related to hardware. Recommended Action Check and replace (if necessary) the hardware attached to both ends of the specified port number, including: • the media (SFPs) • the cable (fiber optic or copper ISL) • the attached devices When finished checking the hardware, perform the portEnable command to re-enable the port. Severity WARNING PORT-1004 Message , [PORT-1004], ,, INFO, , Port () could not be enabled because it is disabled due to long distance. Probable Cause Indicates the specified port is not enabled because other ports in the same group have used the buffers for this port group. This happens when other ports were configured to be long distance. Recommended To enable this port, reconfigure the other E_Ports so they are not long distance or change the other Action E_Ports so they are not E_Ports. This will free some buffers and allow this port to be enabled. Severity INFO PORT-1005 Message Probable Cause , [PORT-1005], ,, WARNING, , Slot port does not support configured L_port. Issue portCfgLport to clear configuration. Indicates the specified port is configured to be an L_port, but the port does not support L_port. If an L_port is connected, then the port will be disabled because the port does not support L_port. If an E_port or F_port is connected, then the port will not come up since it is configured to be an L_port. Fabric OS Message Reference 469 53-1001338-01