HP StorageWorks 64 FW 05.01.00 and SW 07.01.00 HP StorageWorks Embedded Web Se - Page 125
Error 90: Invalid Port Type, Error 89: Not Allowed
View all HP StorageWorks 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Error Messages Table 9: Embedded Web Serve Messages (Continued) Message Error 79: FRU Failed Error 81: Default Zone Enabled Error 82: Invalid Interop Mode Error 83: Not Allowed in Open Fabric Mode Error 88: Invalid Feature Key Length Error 89: Not Allowed in S/390 Mode Without the SANtegrity Feature Error 90: Invalid Port Type Description The specified FRU has failed. The request cannot be completed because the default zone is enabled The value entered for the interoperability mode is not valid. This request cannot be completed while this switch is operating in Open Fabric 1.0 mode. The feature key installed is longer than the maximum length allowed. Cannot configure port types in S/390 mode (FICON management style in HAFM) without installing SANtegrity. The port type configured is invalid. Action Consult the installation/service manual for appropriate action. Disable the default zone and resubmit the command. The interoperability mode for the director or switch must be mcdata (Homogenous Fabric) or open (Open Fabric 1.0). Make the appropriate changes and resubmit the command. Configure the interop mode to Homogenous Fabric mode. Be sure that the key has been entered correctly and resubmit. Contact your sales representative with any further problems. This command is only supported when the switch is in Open Systems mode (Open Systems management style in HAFM) or in S/390 mode (FICON management style in HAFM) with SANtegrity. A port may be configured to be an eport, gport, or fport. Be sure the port is configured appropriately and resubmit the command. Embedded Web Server User Guide 125