HP StorageWorks 64 FW 05.01.00 and SW 07.01.00 HP StorageWorks Embedded Web Se - Page 23
Where to Start, Starting EWS,
View all HP StorageWorks 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Introduction Where to Start Depending upon whether the Hewlett-Packard product you purchased has already been installed, you may need to go to a specific chapter. If the product has not been installed, you should start at Chapter 2. If the product was installed, then many of the configuration tasks were probably already completed. In that case, you may need to configure a zone. Configuring (including adding, deleting, and changing) zones is described in Chapter 3. If the products have been configured and you have a functioning SAN, then you most likely will be interested in performing system administration tasks. Those tasks are described in Chapter 4, Chapter 5, and Chapter 6. If you need to perform troubleshooting, then you will want to review Chapter 5 and Chapter 6. Starting EWS Open the EWS interface as follows: 1. Ensure the workstation (or device you use to launch the web browser) and the Ethernet LAN segment containing the product, such as Edge Switch 2/24, are attached and connected through the Internet. Note: You must be able to make a connection between the web browser and the product in order to login to the product. 2. Launch the web browser application (such as Netscape Navigator, version 4.6 or higher, or Microsoft Internet Explorer, version 4.0 or higher). 3. At the web browser, enter the IP address of the product as the Internet uniform resource locator (URL) such as http://10.1.1.11. Note: If the product has not been installed, refer to the product's installation and service manual for the appropriate IP address, login ID, and password that is initially used when you install and configure the product. Embedded Web Server User Guide 23