HP StorageWorks 8/40 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01 - Page 352
fruReplace, Synopsis, Description, Operands, Examples, See Also
View all HP StorageWorks 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 352 highlights
2 fruReplace fruReplace Synopsis Provides an interactive interface to help replace a field replaceable unit (FRU). frureplace fru Description Use this command to replace a FRU. The command automatically performs the necessary backup and restore operations to accommodate the replacement. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands The following operand is required: fru Specify the type of hardware component being replaced. WWN is the only supported value, specifying the replacement of the WWN card. Examples To replace the world wide name card: switch:admin> frureplace wwn This is the WWN card hot swap interface. Continuing from this point will require the whole process to be completed. If this process is not complete due to a power cycle, or CP failover, please follow the recovery procedure in Core Switch WWN Card Removal and Replacement document. Do you wish to continue [y/n]? y Backing up WWN card data, please wait about 25 seconds for further instruction. Please install the new FRU now. If this session lost for any reason, please re-enter the frureplace command and follow the instructions to complete the operation. Please enter the word `continue' after the new WWN card has been installed: continue Restoring the information to the replacement FRU now, please wait about 20 seconds to complete Verifying the replacement FRU now... WWN card hot swap is now complete. FRU replacement completed successfully! See Also none 322 Fabric OS Command Reference 53-1001337-01