HP StorageWorks 8/8 Brocade Error Message Reference Guide v6.1.0 (53-1000600-0 - Page 517
ZONE System Messages, ZONE-1002
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 517 highlights
Chapter ZONE System Messages 80 ZONE-1002 Message , [ZONE-1002], ,, WARNING, , WWN zoneTypeCheck or zoneGroupCheck warning() at port() Probable Cause Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a failure when creating or adding zone groups during port login (PLOGI) trap processing. This messages usually indicates problems when adding content-addressable memory (CAM) entries before the filter setup. Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the Action supportSave command and contact your switch service provider. Severity WARNING ZONE-1003 Message , [ZONE-1003], ,, WARNING, , zone() contains (, ) which does not exist. Probable Cause Indicates that the port zone member that is targeted for the local switch contains a non-existent port. The effective zoning configuration (displayed in the error message) contains a port number that is out of range. Recommended Edit the zone database and change the port number to a viable value in the effective configuration. Action Severity WARNING ZONE-1004 Message Probable Cause , [ZONE-1004], ,, INFO, , port enforcement changed to Session Based HARD Zoning. Indicates that the zoning enforcement changed to session-based hard zoning. When a device is zoned using both world-wide name (WWN) in one zone and in another, this will cause that port to go session based hard zoning. Fabric OS Message Reference 465 53-1000600-02