HP StorageWorks 8/8 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, - Page 213
defZone, Using Fabric OS commands, Command, Availability, d_efault_Cfg
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
defZone 2 defZone Sets or displays the default zone access mode. Synopsis defzone [--noaccess | --allaccess | --show] Description Use this command to display or set the Default Zone access mode. Setting the Default Zone mode initializes a zoning transaction (if one is not already in progress), and create reserved zoning objects. A default zone controls device access when zoning is not enabled. When a user-specified zoning configuration is not enabled, Default Zone is in effect, allowing access to all devices. When a user-specified zone configuration is enabled, it overrides the Default Zone access mode. Notes This command must be run from the primary FCS switch. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Zone object names beginning with the d_efault_ prefix are reserved for default zoning use. Editing of these objects is not permitted. Therefore, cfgShow does not display the names of these objects. If d_efault_Cfg is the effective zone configuration, both cfgShow and cfgActvShow do not display d_efault_Cfg as the effective zone configuration. Operands This command has the following operands: --noaccess Sets the default zone access mode to No Access, initializes a zoning transaction (if one is not already in progress), and creates the reserved zoning objects equivalent to the following zoning commands: cfgCreate "d_efault_Cfg", "d_efault_Zone" zoneCreate "d_efault_Zone", "00:00:00:00:00:00:00:01" A cfgSave, cfgEnable, or cfgDisable command must be issued after issuing this command to commit the changes and distribute them to the fabric; for example: primaryfcs:admin> defzone --noaccess primaryfcs:admin> cfgsave An audit log record is generated for each execution of this command. When No Access default zone is activated, the following conditions apply: • If the current effective zone configuration is disabled with the cfgDisable command, the local switch converts this command to the equivalent of cfgEnable d_efault_Cfg. • If zoning receives a cfgDisable command from a remote switch that does not support default zoning, zoning rejects the cfgDisable command in the second phase of RCS because the remote switch does not convert the cfgDisable command to cfgEnable d_efault_Cfg. Fabric OS Command Reference 183 53-1001337-01