HP StorageWorks 8/8 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, - Page 877
switchBeacon, Synopsis, Description, portLoopbackTest, switchShow, Operands, Examples, See Also
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 877 highlights
switchBeacon 2 switchBeacon Synopsis Sets switch beaconing mode on or off. switchbeacon [mode] Description Use this command to enable or disable switch beaconing mode. Switch beaconing can be used to locate a failing unit. When beaconing mode is turned on, the port LEDs flash amber, left to right and right to left, from port 0 to the highest port number and back to port 0. The beaconing mode continues until you turn it off. The beaconing LED pattern continues until you turn it off. Beaconing mode takes over the port LEDs. Other commands are still executable and functional. The normal flashing LED pattern (associated with an active, faulty or disabled port for example) is suppressed and only the beaconing pattern is shown. However, if diagnostic frame-based tests (such as portLoopbackTest) are executed, two patterns are interleaved. The diagnostic test flickers the LEDs green and the beaconing mode runs the LEDs amber at the same time. Use the switchShow command to display the status of beaconing. Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operand: mode Specify 1 to enable beaconing mode or 0 to disable beaconing mode. This operand is optional. If no operand is specified, the current value is displayed. Examples To turn beaconing mode on: switch:admin> switchbeacon 1 See Also To turn beaconing mode off: switch:admin> switchbeacon 0 switchShow Fabric OS Command Reference 847 53-1001337-01