HP StorageWorks 8/8 Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, - Page 321
ficonCupSet, bitname, seconds, Using Fabric OS commands, Command, Availability
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
ficonCupSet 2 ficonCupSet Sets FICON-CUP parameters for a switch. Synopsis ficoncupset fmsmode enable | disable ficoncupset modereg bitname 0 | 1 ficoncupset MIHPTO seconds Description Use this command to set FICON-CUP (Control Unit Port) parameters for a switch. All parameters can be set while the switch is online. Changes made by this command take effect immediately. A reboot is not required. Use ficonCupShow to display current settings. Notes FICON Management Server (FMS) mode cannot be enabled if port ID (PID) Format 2 is used. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. Operands This command has the following operands: fmsmode Enables or disables the FICON Management Server (FMS) mode for the switch. modereg bitname 0|1 Set a bit in the FICON-CUP mode register. The following operands are required: Specifies a given bit value to be (1) set or not set (0). Valid values for bitname are POSC Programmed offline state control UAM User alert mode ASMA Active=saved mode DCAM Director clock alert mode ACP Alternate control prohibited HCP Host control prohibited MIHPTO seconds Sets the missing interrupt handler primary timeout (MIHPTO) value for the CUP. The following operand is required: Specifies the timeout value in seconds. Provide a decimal value in the range between 15 and 600 seconds. The default timeout value is 180 seconds. If a value greater than 63 seconds is specified, the timeout value is rounded down to the closest value divisible by 10. For example, an MIHPTO timeout value of 86 defaults to 80. Examples To enable FMS mode for the switch: switch:admin> ficoncupset fmsmode enable fmsmode for the switch is now Enabled Fabric OS Command Reference 291 53-1001337-01