HP Surestore Tape Library Model 10/180 SAN Solution Installation Guide - Page 24
Managing the Switch Using the Telnet Options
View all HP Surestore Tape Library Model 10/180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Table 2-1 Installation Switches If the default address cannot be used in your network configuration, you will need to make a serial (RS-232) connection to the switch using terminal emulation software. To do this, you will need a standard serial cable with a female 9-pin D-Sub connector for the switch connection and an appropriate connector for the host/terminal being used. The cabling pinout is described in the table below. Serial Connection Pinout for Brocase SilkWorm™ 2400 Switch Pin 1 2 3 4 5 6 7 8 9 Signal TxData RxData GND CTS - Description Transmit data Receive data Logic ground Clear to send (must be driven high) - Managing the Switch Using the Telnet Options: 1. Connect the host system and the switch using the serial cable. 2. Start the terminal emulation software on the host system. 3. Power-on the switch. The switch will automatically connect, and you will be logged in as admin. If you are prompted for a login and password: 1. Enter [admin] and [password] respectively. 2. Enter the command [ipAddrSet]. You will be prompted to enter the Ethernet and FC IP addresses, subnet mask, and gateway address. 3. If the current value displayed is correct, select [ENTER]. The switch should now be accessible using Telnet. 2-6 Chapter 2