HP Surestore Tape Library Model 10/180 SAN Solution Installation Guide - Page 43
Drive Entries
View all HP Surestore Tape Library Model 10/180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
NOTE NOTE Installation Tape Libraries 4. When the screen displays your desired setting, press the [SELECT] button from the right-most field to save the changes. To abort, press the [MENU] button from the left-most field. 5. If you have already changed the library's SCSI ID and are planning to exit the Main Configuration menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section, "Drive Entries." Drive Entries Information in this section refers to the 9840, DLT 7000 and DLT 8000 drives. For you to be able to configure a 9840 drive's SCSI ID and bus status from the library's operator panel, the drive must have firmware version 1.24 or later. To check the drive's firmware version, select [DRIVE INFO] from the main menu. Configuring a tape drive might involve more than setting the drive's SCSI ID and bus status. For more information about 9840 drive configuration options and instructions, refer to the 9840 Tape Drive Installation Guide, Part Number A5598-96001.. Two entries at the library operator panel complete the configuration choices for each drive installed in the library. • SCSI ID • Bus status (on or off bus) "On Bus" means that the drive is on the same SCSI bus as the library. "Off Bus" means that the drive is not on the same SCSI bus as the library. You can set the drive SCSI IDs and bus status choices from the Drive Configuration menu. You can enter both values for each drive at the same time: 1. At the Main Configuration menu, press an arrow key until the cursor underscores DRIVE CONFIG. Chapter 2 2-25