HP Surestore Tape Library Model 10/180 HP Tape Library Configuration Guide - Page 7
Sun Solaris
![]() |
View all HP Surestore Tape Library Model 10/180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Sun Solaris For Sun Solaris operating systems, perform the following operating system configurations: • Install the appropriate host bus adapter(s) • Install the corresponding drivers for the interface card(s) • Install the backup software To verify the installation, look for the library and drive after powering up the host. 1. Close all open applications and exit the Common Desktop Environment (CDE). 2. Type "init 0" at any prompt. This will shut down all processes, and take you to the OpenBoot PROM. 3. Type "reset". 4. At the OK prompt, type "probe-scsi-all". Run a test backup to ensure that all components are properly configured. Configuring the Host System 5
![](/manual_guide/products/hewlettpackard-surestore-tape-library-model-220-hp-tape-library-configuration-guide-61dd88f/7.png)
Configuring the Host System
5
Sun Solaris
For Sun Solaris operating systems, perform the following operating
system configurations:
•
Install the appropriate host bus adapter(s)
•
Install the corresponding drivers for the interface card(s)
•
Install the backup software
To verify the installation, look for the library and drive after powering
up the host.
1.
Close all open applications and exit the Common Desktop
Environment (CDE).
2.
Type °init 0± at any prompt. This will shut down all processes,
and take you to the OpenBoot PROM.
3.
Type °reset±.
4.
At the OK prompt, type °probe-scsi-all±.
Run a test backup to ensure that all components are properly
configured.