HP Surestore Tape Library Model 6/140 SAN Solution Installation Guide - Page 36
Enabling Auto Clean, DO NOT, Powering-on the Library
View all HP Surestore Tape Library Model 6/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
NOTE CAUTION Installation Tape Libraries During an initialization or IPL (Initial Program Load), the library automatically verifies and loads some configuration values, such as drive locations, Auto Clean status, capacity, and drive types. Before the library is fully operational, you must enter the remaining configuration values. You can enter the values through the operator panel. You may need to consult with your system administrator for additional information. Enabling Auto Clean It is recommended that you DO NOT enable Auto Clean as it may interfere with the operation of backup software. Enabling the Auto Clean feature allows the library to initiate drive cleaning without operator intervention. The Auto Clean feature is automatically enabled if you load even one cleaning cartridge into the reserved cell area and then power-on or reset the library. Powering-on the Library powering-on the library supplies power to the library electronics and to the drive column. It also initiates an initial program load (IPL). 2-18 Chapter 2