HP TC1000 Maintenance and Service Guide, Compaq Tablet PC TC1000 - Page 128
Removing the Docking Stand and Pivot Arm, One PM2.5 × 12.0 screw
UPC - 613326724071
View all HP TC1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Removal and Replacement Procedures ✎ Make sure the docking stand and pivot arm are supported before removing the following screws. The docking stand and pivot arm can fall if not supported. 7. Remove the following screws: ❏ Two PM2.5 × 5.0 screws 1 that secure the cable bracket to the bottom case (Figure 5-33) ❏ One PM2.5 × 12.0 screw 2 that secures the pivot arm hinge to the bottom case ❏ Three PM2.5 × 6.0 screws 3 that secure the pivot arm hinge to the bottom case 8. Remove the docking stand and pivot arm 4. Figure 5-33. Removing the Docking Stand and Pivot Arm 5-40 Maintenance and Service Guide
5–40
Maintenance and Service Guide
Removal and Replacement Procedures
✎
Make sure the docking stand and pivot arm are supported before
removing the following screws. The docking stand and pivot arm
can fall if not supported.
7. Remove the following screws:
❏
Two PM2.5 × 5.0 screws
1
that secure the cable bracket
to the bottom case (Figure 5-33)
❏
One PM2.5 × 12.0 screw
2
that secures the pivot arm
hinge to the bottom case
❏
Three PM2.5 × 6.0 screws
3
that secure the pivot arm
hinge to the bottom case
8. Remove the docking stand and pivot arm
4
.
Figure 5-33. Removing the Docking Stand and Pivot Arm