HP TouchSmart tm2t-2100 HP TouchSmart tm2 Notebook PC - Maintenance and Servic - Page 66
Display assembly, Remove the display assembly
View all HP TouchSmart tm2t-2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Display assembly Description Spare part number 12.1-inch, WXGA, BrightView, LED touch-screen display assembly (includes Web camera and cable, 611492-001 microphones and cables, fingerprint reader and cable, WLAN antenna cables, and WWAN antenna cables) Before removing the display assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power cord. 4. Remove the battery (see Battery on page 36). 5. Disconnect the WLAN antenna cables from the WLAN module (see WLAN module on page 44). 6. Remove the hard drive (see Hard drive on page 38). 7. Remove the top cover (see Top cover on page 49). Remove the display assembly: 1. Close the computer and turn it upside down, with the rear panel toward you. 2. Remove the two Phillips PM2.0×4.0 screws that secure the display hinge cover to the computer. 3. Turn the computer display-side up, with the rear panel toward you. 4. Open the computer display to the upright position and rotate the display (1) 90-degrees clockwise. 56 Chapter 4 Removal and replacement procedures