HP Workstation xw8000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 147
on this controller with no file system on it as evidenced by, displayed in
View all HP Workstation xw8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
container Commands Table 5-5 summarizes the values for the /write_cache_enable and /unprotected switches: Table 5-5. Switch Values and Results /write_cache_enable Switch Setting FALSE FALSE TRUE TRUE /unprotected Switch Setting FALSE TRUE FALSE TRUE Result The NVRAM write-back cache setting for the specified array is disabled. Not allowed. An appropriate error message displays. The NVRAM write-back cache setting for the specified array is enabled when protected. This means the controller enables the array's NVRAM write-back cache only if a battery is present and its status is OK. The NVRAM write-back cache setting for the specified array is enabled always. This means the controller forces the enabling of the array's NVRAM write-back cache even if write data could be lost due to no battery or a bad battery. Examples Before setting cache parameters for a specific array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller with no file system on it (as evidenced by None displayed in the Usage column): AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB 5-99