HP Workstation xw8000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 229
disk verify
View all HP Workstation xw8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
disk Commands disk verify To verify all blocks on a SCSI disk device and, optionally, repair any bad blocks, use the disk verify command. Syntax disk verify [/repair{=boolean}] [/wait{=boolean}] {scsi_device} Parameters {scsi_device} Specifies the ID for the SCSI disk device that you want to verify. A SCSI ID consists of a SCSI channel number (for example, 0, 1, 2, 3, etc.), a SCSI device ID (0 through 15 inclusive), and a SCSI logical unit number (0 through 7 inclusive). See the scsi_device section on page 3-7 for more information on how to specify the SCSI device. Switches /repair{=boolean} Specifies whether to automatically repair bad blocks. If you set this switch to TRUE, the command attempts to repair any bad blocks. If you do not specify the switch, the command only reports failures. This switch defaults to FALSE. /wait{=boolean} Specifies whether to perform verification synchronously or asynchronously. If you set this switch to TRUE, the command performs the block verification synchronously and the command prompt does not return until the block verification operation completes. The default is FALSE; that is, the command performs the block verification asynchronously and the command prompt returns immediately. 7-29