HP Z600 HP 22-in-1 Media Card Reader Installation - Page 4
Preparing the computer
UPC - 884962074053
View all HP Z600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
f. The green carrier latch (5) snaps into place when fully seated. Figure 3 Installing the media reader in the bay adapter Preparing the computer NOTE: Computer models vary. All illustrations are examples only. Accessing the internal components of the computer 1. If you need help preparing the computer for this installation, consult the removal and replacement procedures in the service guide for your computer at http://www.hp.com/support/ manuals. 2. Power down the computer, and then disconnect the power cord. 3. Power down all external devices, and then disconnect them from the computer. 4. Remove the side access panel. Removing components 1. If present, remove the card support to access the system board connectors. 2. If present, remove the airflow guide to access the optical bays. 3. Remove the front bezel, if required to install a device in the optical bay. NOTE: The front bezel does not need to be removed to install the media reader in HP Z600 and Z800 Workstations. 4. Remove the bezel blank cover or filler tray from the optical drive bay (or remove the drive from the bay if you are replacing an existing drive with the media card reader and do not have an empty drive bay). 4 HP 22-in-1 Media Card Reader ENWW