HP st5747 Troubleshooting Guide: HP t5740/t5745 Thin Clients and HP st5742/st5 - Page 13

Installing the Rubber Feet, Installing the Stand,

Get HP st5747 - Streaming Client PDF manuals and user guides View all HP st5747 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Installing the Rubber Feet To install the rubber feet: 1. Lay the thin client on its right side. 2. Remove the feet from their backing. 3. Press each foot down securely onto a corner of the left side of the thin client. Figure 1-6 Installing the rubber feet Installing the Stand If the thin client will be installed in an vertical orientation and it will not be mounted, the stand should be installed for stability. To install the stand: 1. Turn unit upside down. 2. Locate the slots on the bottom of the unit into which the tabs on the stand fit. 3. Insert the tabs into the slots (1), and then slide the stand about 1.26 cm (1/2 inch) toward the back of the unit until it locks into place (2). Figure 1-7 Installing the stand Product features 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Installing the Rubber Feet
To install the rubber feet:
1.
Lay the thin client on its right side.
2.
Remove the feet from their backing.
3.
Press each foot down securely onto a corner of the left side of the thin client.
Figure 1-6
Installing the rubber feet
Installing the Stand
If the thin client will be installed in an vertical orientation and it will not be mounted, the stand should
be installed for stability.
To install the stand:
1.
Turn unit upside down.
2.
Locate the slots on the bottom of the unit into which the tabs on the stand fit.
3.
Insert the tabs into the slots (1), and then slide the stand about 1.26 cm (1/2 inch) toward the
back of the unit until it locks into place (2).
Figure 1-7
Installing the stand
Product features
5