HP t628 t628 Thin Client - Page 38
Replace the thin client stand
View all HP t628 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
15. Insert the four screws (2) through the sides of the hard drive bracket into the 2.5-inch hard drive and tighten to secure the hard drive in the bracket. 16. Hold the hard drive bracket with the open end toward the rear of the thin client. Set the bracket (1) into the chassis and slide the bracket toward the rear to engage the retaining screw. NOTE: If you are installing a hard drive, be sure that the hard drive connectors are connected. 17. Insert the three screws (2) and tighten them to secure the hard drive bracket to the chassis. 18. Replace the access panel. See Removing and replacing the access panel on page 9. 19. Replace the thin client stand. 20. Reconnect external devices, reconnect the power cord, and then turn the thin client on. 21. Lock any security devices that were disengaged when the thin client access panel was removed. 32 Chapter 3 Hardware changes