Hitachi 32PD7800 Owners Guide - Page 21
OPERATING INSTRUCTIONS, Turning Power On and Off
View all Hitachi 32PD7800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ENGLISH OPERATING INSTRUCTIONS Main power switch Indicating lamp (32) (37) (42) SUB-POWER button POWER ON/OFF button Turning Power On and Off • To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button of control panel or the power button on the remote control. • To turn the monitor power OFF, press the SUB POWER button of control panel or the power button on the remote control, and then press the main power switch on the monitor main unit to OFF. • During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the power button on the remote control. Indicating lamp Indicating lamp Off Power status Operating Off When the main power switch is set to OFF. Lights red Off (standby) When the main power switch is ON, and the power button on the remote control or the SUB POWER button on the underside of the front of the frame is OFF. Lights green When the main power switch is ON, and the power button on the remote control On or the SUB POWER button on the underside of the front of the frame is ON. Lights orange Off (Power Save) When the main power switch is ON, and the power button on the remote control or the SUB POWER button on the underside of the front of the frame is ON. However, the state in POWER SAVE mode When the indicating lamp lights in orange or the message "No Sync. Signal", "Power Save" or "Invalid Scan Freq." appears on the screen, there is something unusual about the status of reception. See "Power Save Mode" or "Symptoms That Seemingly Appear to be Failures." 48 49 50 ATTENTION • Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation. • Turn off the main power switch before leaving the monitor out of use for an extended period of time. • If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit. 21