Hitachi 32PD7800 Owners Guide - Page 38

OPERATING INSTRUCTIONS continued, SETUP MENU RGB mode: RGB1 DVI-PC, RGB2 RGB Continued

Get Hitachi 32PD7800 PDF manuals and user guides View all Hitachi 32PD7800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

OPERATING INSTRUCTIONS (continued) SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (Continued) Selected characters Vertical Filter Off On Setup hint Turn On when concerned about screen flicker. Frequency Mode Movie PC Set to Movie when viewing moving images on a personal computer. RGB1 DVI-PC DVI-STB This should correspond to the signal mode of the signal from the equipment that is connected to RGB1 DVI terminal. RGB2 (1st step) RGB Component This should correspond to the signal mode of the signal from the equipment that is connected to RGB2 D-sub terminal. RGB2 (2nd step) Auto HDTV SDTV/DVD This step should be set only when [Component] is selected on the 1st step. This should correspond to the signal mode of the signal from the equipment that is connected to RGB2 D-sub terminal. • Normally, set this to Auto. The signal mode of the input signal will be automatically recognized. • If the input signal contains much noise or has a low level at Auto and the operation is found erratic, set this to match the input signal. * Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
38
Movie
PC
DVI-PC
DVI-STB
RGB
Component
Auto
HDTV
SDTV/DVD
Off
On
Selected characters
Setup hint
Vertical Filter
Frequency Mode
RGB1
RGB2 (1st step)
RGB2 (2nd step)
Turn On when concerned about screen flicker.
Set to Movie when viewing moving images on a personal computer.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
This step should be set only when [Component] is selected on the
1st step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
•
Normally, set this to Auto. The signal mode of the input signal will
be automatically recognized.
•
If the input signal contains much noise or has a low level at Auto
and the operation is found erratic, set this to match the input signal.
OPERATING INSTRUCTIONS (continued)
SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (Continued)
*
Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them.