Hitachi DK23FB-60 Owners Manual - Page 51
Power Commands, 3.2.6.1 Power Management
UPC - 706569123807
View all Hitachi DK23FB-60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
6.3.2.6 Power Commands 6.3.2.6.1 Power Management Supported commands and functions: - Idle command - Idle Immediate command - Sleep command - Standby command - Standby Immediate command - Advanced Power management(APM)* - Standby timer (1) Low power consumption modes The drive supports the following low power consumption modes. Active mode : The spindle motor is rotated. Seek and Read/Write operations are activated. However, the power mode is moved to Low Power Active mode if the host does not issue any command within 200 ms after previous command completion. The Low Power Active mode is a low power consumption mode cutting the power of the drive control circuit, but the drive is keeping the active state of Seek and Read/Write operations. Idle mode: Refer to Sec. 6.3.2.6.2 "Advanced Power Management". Standby mode: State of ready to receive commands. State of ready to receive commands, but the spindle motor is stopped. If the device receive a command with seek operation, the spindle motor is rotated and the command is executed. Sleep mode: This mode is the lowest power mode. The spindle motor is stopped. The device cannot receive the command except Hardware Reset and Software Reset. (2) Standby/Sleep command Operation Standby, Standby Immediate and Sleep commands are executed with the following process. - Wait write command completion - Unload heads - Clear BSY bit and enable INTRQ signal - Stop the spindle motor - Move to a low power mode K6610007 Rev.5 02.14.'03 - 51 -