Hitachi NV83A2 Instruction Manual - Page 14

English (1) Press the magazine stopper and open the magazine cover. (4) Close the magazine cover. (5) Grip the nail guide and knob with finger. Press the knob down and swing the nail guide open. Magazine Stopper Magazine Cover (2) Adjust the position of the nail holder according to the nail length. The nail will not feed smoothly if the nail holder is not correctly adjusted. 1 Lift the nail holder. 2 Turn the nail holder to align the mark with the numbers (1-1/4"(32 mm), 1-1/2"(38 mm), 1-3/4"(45 mm), 2"(50 mm) on the magazine cover. For 1-1/4"(32 mm) For 1-1/2"(38 mm) For 1-3/4" and 2" (45 mm and 50 mm) Magazine Cover Mark Nail Holder NOTE: Before loading nails in the magazine, adjust the plate. If the magazine cover is forcibly closed without adjusting the nail holder correctly, the nail holder may be damaged. (3) Place the nail coil into the magazine. Insert the first nail into the magazine opening. First Nail Magazine Opening Magazine Knob Nail Guide (6) 1 2 3 Uncoil enough nails to reach the driving hole. Insert the first nail into the driving hole and the second nail between the two pawls of the feeder. Fit the nail heads in the guide slot. Driving Hole Guide Slot FirstNail 2 3 Nail Guide 4 1 Guide Surface 2 Feeder NOTE: Be careful not to deform the collated wires and not to disengage the nails with the guide surface. Otherwise, the nail guide will not close correctly. 4 Pulling the nails to the right, swing the nail guide closed. (7) Lock the knob completery. NAILER OPERATION Read section titled "SAFETY" (pages 4 - 7). DANGER ⅷ Operators and others in work area MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications. Nail - 14 -