HoMedics EL-200 User Manual - Page 8

Kneading Kneading combines a circular motion while moving up and down the back. Tapping Tapping combines a rapid back and forth tapping along the back while moving up and down the full length of the back. Kneading +Tapping Kneading+Tapping combines the circular motion of Kneading with Tapping while moving up and down the back. Adjustable Functions in Manual Massage These functions are available when one of the Manual Massage Functions is active. To activate one of these functions, simply press the desired button while in a manual massage function. The corresponding LED will illuminate to confirm your selection. Spot A stationary version of 3 of the manual massage functions, which can be adjusted up and down with the Up/Down controls. Spot stops the massage in the location in which it was pressed and focuses the massage action in that place. Available with: Kneading, Tapping, and Kneading+Tapping. NOTE: By definition, Rolling, which moves up and down, is not available in Spot. However, Rolling can be focused to a specific area with the Partial function. See below. Partial A partial range version of all the manual massage functions, which can be adjusted up and down with the Up/Down controls. Partial stops the massage action in the location in which it was pressed and then works approximately a 4" range up and down. Available with: Rolling, Kneading, Tapping, and Kneading +Tapping. Up/Down Available with the Spot and Partial functions, the Up/Down button adjusts the location of the massage to a specific position along the back. To move the massage location up or down, press and hold the respective button until you have reached the desired location. When you release the button, the massage location will be set. Available with: Spot and Partial Massage Tapping Intensity Adjusts the intensity of the Tapping functions between Low (L) and High (H). The LED light indicates the intensity level. To change the intensity level, simply press the button. Available with: Tapping and Kneading+Tapping Width Adjusts the location of the massage rollers in Rolling and Tapping with 3 setting options. Width control allows you to change the position of the massage rollers so that you can customize the massage. The LED light indicates the width setting. To adjust the width of the massage rollers, simply press the button. Repeat until you have reached the desired setting. Available with: Rolling and Tapping Automatic Shut Off The eLounger has been designed for convenience and safety. As a special precaution against falling asleep while using the unit or leaving the unit on while it is still in operation, we've programmed it to automatically shut off after 20 minutes. This special feature should not be considered as a substitute for OFF. Always remember to turn your unit off when not in use. NOTE: If you do not use the eLounger for a period of time (for instance, while you are away on vacation) it is recommended that you turn off the master power switch and unplug the chair. 14 15