Honeywell CT3451 Owner's Manual - Page 7

- Press the ▲ key. Current configuration (CC) is displayed. A typical example is shown, but CC varies by model. (This information is for factory use only.) M14692 ❑ Exit Installer Setup. - Press the ▲ key to save all changes and return to normal operation. PM M12590A Table 2. Heating Cycle Rate. System Steam, gravity Hydronic heat, condensing gas furnacesa Gas or oil forced air (default) Electric heat Special applications Cycle Per Hr 1 3 6 9 4, 5, 12 aHigh efficiency furnace (90+). bRefer to the equipment manufacturer's instructions. 9 PROGRAM YOUR THERMOSTAT The thermostat is preprogrammed for your convenience with the following time and temperature settings; see Table 3. See energy saving charts at the end of this document for energy-saving information. Table 3. Preprogrammed Time and Temperature Settings. Period Wake Time 6:00 AM Heat Setpoint 70°F (21°C) Cool Setpoint 78°F (26°C) Leave Return 8:00 AM 6:00 PM 62°F (17°C) 70°F (21°C) 85°F (29°C) 78°F (26°C) Sleep 10:00 PM 62°F (17°C) 82°F (28°C) Wake is the time period when you want the house at a comfortable temperature when you get up in the morning. CT3451 PROGRAMMABLE THERMOSTAT NOTE: The heating and cooling program times are the same. Changing your cooling Wake time also changes your heating Wake time. Leave is the time period you can set for an energy saving temperature while you are away from home during the day. Return is the time period when you want the house at a comfortable temperature when you come home during the day. Sleep is the time period when you can set an energysaving temperature while you are sleeping. IMPORTANT Always press the keys with your fingertip or similar blunt tool. Sharp instruments like pens and pencil points can damage the keyboard. Setting Current Time and Day 1. To set current time, press Select twice. Press ▼ or ▲ key to set current time. NOTE: While setting the current time, the word SET is displayed. SET PM M12591A 2. To set day of week, press Select again. Press▼ or ▲ key to set current day. SET M18534 To use the preprogrammed time and temperature settings (see Table 3), press Hold to exit the programming mode. Setting Weekday Program Slide the System switch to the position, Heat or Cool, that you want to program. A flame (heating) or a snowflake (cooling) appears in the right side of the display, when setting the program temperature. 1. Wake a. Press Select. Press ▼ or ▲ key to set Wake time. SET M18570 b. Press Select. Press ▼ or ▲ key to set Wake temperature. 7 69-1620-1