Hoover S3755 Manual - Page 6

2-7 2-8 2-9 F G Edge cleaning Special edge groomers are provided on both sides of the nozzle to remove dirt in carpet near baseboards and furniture. Guide side of nozzle parallel to edge of carpet or furniture as shown. How to clean stairs Place cleaner on stair. Using the furniture nozzle, clean stairs from bottom to top. H Cleaning tools The cleaning tools are conveniently stored in the cleaner underneath the tool lid. Pull up on edge of lid in recessed area to open. A tool may be attached to either the hose or telescoping wand by pushing it firmly onto the hose end or the end of the wand. Twist tool slightly to tighten or loosen the connection. The cleaning tools have many uses. Select the tool best suited for the cleaning task from the following descriptions. 3. Maintenance Dirt cup When to empty 3-1 B Select the proper tool F. Dusting brush/furniture nozzle this 2-in-1 tool may be used with the brushes in place (dusting brush) for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters and registers. Remove the brushes (furniture nozzle) and use it for upholstered furniture, draperies, tapestries, mattresses, clothing, automobile interior and carpeted stairs. G. Crevice tool may be used in tight spaces, corners, and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. H. Small brush is used for cleaning the dirt cup filter. How to empty Turn cleaner off and disconnect from electrical outlet. Press the button (B) on the top of the cleaner and pull the dirt cup straight out. Remove dirt cup lid and empty the cup. 3-2 A The dirt cup needs emptying before the dirt reaches the "MAX" line (A) on the dirt cup or after every use if preferred. CAUTION: Very fine materials, such as face powder, cornstarch, fireplace ashes or fireplace soot, may seal the filter and cause loss of suction. When using the cleaner to remove this type of dust, empty the cup and clean the filters often. C C Should the dirt cup platform flaps (C) become dislodged, refit using the diagram on the platform. 6